User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*SUPerModulationLevelCountersTxFailed
elCountersEntry 4)
-
ng
t the
(*PerModulationLev
Applicable to SU/RB. Read
only. The total number of
failures to successfully
transmit a unicast frame duri
a HW Retry cycle a
applicable modulation level.
Counter 32
*AverageModulationLevel
(*PerModulationLevelCounters 3)
t
Integer
1-8.
Applicable to SU/RB. Read-
only. The average modulation
level for successful
transmission (rounded to
nearest integer) since last rese
of the Per Modulation Level
counters.
*MacAddressDatabase
(*SiteSurvey 5)
MAC Address Database
*AUMacAddressDatabase
atabase
(*MacAddressDatabase 1)
AU MAC Address D
*AdbResetAllCounters
(*AUMacAddressDatabase 1)
Integer
reset (1)
noReset (2)
Applicable to AU/BU. Resets
all the counters for all SUs in
the MAC Address Database.
*AUAdbTable
(*AUMacAddressDatabase 2) C
able.
Applicable to AU/BU. Not
accessible. The AU MA
Address Database T
*AUAdbEntry
(*AUAdbTable 1)
Applicable to AU/BU. Not
accessible. An entry in the AU
MAC Address Database Table.
*AdbIndex
(*AUAdbEntry 1)
Integer
Applicable to AU/BU. Read-
only. The Index of an entry in
the AU MAC Address
Database Table.
*AdbMacAddress
(*AUAdbEntry 2)
Applicable to AU/BU. Read-
only. The MAC Address of an
SU entry in the AU MAC
Address Database Table.
MAC Address
*AdbStatus
(*AUAdbEntry 3) s of the
Integer
associated (1)
d (2)
ated
(3)
Applicable to AU/BU. Read-
only. The wireless statu
relevant SU. authenticate
notAuthentic
*AdbSwVersion
(*AUAdbEntry 4)
Display String Applicable to AU/BU. Read-
only. The SW Version of the
relevant SU.
*AdbSNR ead- Integer
(*AUAdbEntry 5)
Applicable to AU/BU. R
only. The average Signal to
Noise Ratio in dB of frames
received by the AU from the
relevant SU.
0-60
*AdbMaxModulationLevel
(*AUAdbEntry 6)
Integer
Range: 1 to 8*
*Level 8 is not
applicable to
devices with HW
revision A.
Applicable to AU/BU. Read-
only. The value configured in
the relevant SU for the
Maximum Modulation Level
parameter.
*AdbTxFramesTotal
(*AUAdbEntry 7) r
t were
transmitted by the AU to the
relevant SU.
Counter 32 Applicable to AU/BU. Read-
only. Counts the total numbe
of frames (excluding
retransmissions) tha
BreezeACCESS 4900 System Manual
203