User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*NoOfDuplicateFramesDiscarded
(*WirelessLinkCounters 8)
Applicable to all units.
Read-only. The number of
frames discarded due to
receiving multiple copies.
Counter 32
*InternallyDiscardedMirCir
(*WirelessLinkCounters 9) ta
/CIR
ng
Counter 32
Applicable to all units.
Read-only. The number of da
frames received from the
Ethernet port that were
discarded by the MIR
mechanism to avoid exceedi
the maximum allowed
information rate
*TotalRxConcatenatedFramesDouble
0)
to all units Read-
double concatenated frames
wireless medium, including
Counter 32
(*WirelessLinkCounters 1
Applicable
only. The total number of
that were received from the
duplicate frames.
*TotalRxConcatenatedFramesSingle
(*WirelessLinkCounters 11)
ere
te
2
Applicable to all units Read-
only. The total number of single
concatenated frames that w
received from the wireless
medium, including duplica
frames.
Counter 3
*TotalRxConcatenatedFramesMore
(*WirelessLinkCounters 12)
plicate
Counter 32
Applicable to all units Read-
only. The total number of
ore concatenated frames with m
than two data frames that were
received from the wireless
medium, including du
frames.
*WirelessLinkEven
(*TrafficStatistics 4)
ts Applicable to all units. Wireless
link event counters.
*TxEvents
nkEvents 1) s.
(*WirelessLi
Applicable to all units.
Read-only. Tx event counter
*DroppedFrameEvents
(*TxEvents 1) s that were
use they were
retransmitted to the maximum
Applicable to all units. The
number frame
dropped beca
allowed number of
retransmissions without being
acknowledged.
Counter 32
*FramesDelayedDueToSwRetry Applicable to all units. Not
applicable for units running SW
version 3.0 and higher. The
number of frames that were
delayed because the SW retry
32
(*TxEvents 2)
algorithm was activated on a
previous frame designated for
the same recipient.
Counter
*Underrun Events
(*TxEvents 3)
was aborted
because the rate of submitting
Applicable to all units. The
number of frames whose
transmission
frames for transmission
exceeds the available
transmission capability.
Counter 32
BreezeACCESS 4900 System Manual
201