User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*MulticastModulationLevel Applicable to AU/BU. The
modulation level for multicast
and broadcast data frames.
Range: 1 to 8*
*Range depends
n
and Min/Max
Modulation
Levels as
defined by Sub-
Band.
(*PerformanceParams 6)
Integer
on HW versio
*AvgSNRMemoryFactor
(*PerformanceParams 7)
TPC
DisplayString
-1 (Disregard
History) to 32
Applicable to all units. The
weight of history in average
RSSI calculation for the A
(AU only) and Adaptive
Modulation algorithm. The
higher is the value, the higher is
the weight of history
*HardwareRetries
(*PerformanceParams 8)
ed
Integer
1-15
Applicable to all units. The
maximum number of trials to
transmit an unacknowledg
frame in each Hardware
Retrials phase.
*AdaptiveModulationParams
(*PerformanceParams 9)
Adaptive Modulation
Parameters
*AdaptiveModulationAlgorithmOption
(*AdaptiveModulationParams 1)
l units.
daptive
Integer
enable (2)
Applicable to al
Enabling/disabling the A
Modulation algorithm.
disable (1)
*SoftwareRetrySupport
(*AdaptiveModulationParams 2) sion
he
are Retry
d
on is
Integer
disable (1)
enable (2)
na (255)
Applicable to all units.
Read-only for units with ver
2.0. Not applicable for units with
SW version 3.0 and higher. T
status of the Softw
mechanism.
Enabled when the Adaptive
Modulation algorithm is enable
and the Burst Mode Opti
disabled. Otherwise it is
disabled.
*NumberOfSoftwareRetries its.
Read-only for units with version
2.0. Not applicable for units with
SW version 3.0 and higher. The
maximum number of times to
use the Software Retry
mechanism when it is enabled.
Integer
(*AdaptiveModulationParams 3)
Applicable to all un
0-14
*MinimumIntervalBetweenAdaptiveModulation
(*AdaptiveModulationParams 4)
two
1-3600
(seconds)
AlgorithmMessages
Applicable to all units. The
minimum interval between
consecutive adaptive
modulation algorithm messages
carrying information on the
SNR of received signals.
Integer
*AdaptiveModulationDecisionThresholds
(*AdaptiveModulationParams 5)
its. Defines
the setting of thresholds for the
rate decision algorithm. high (2)
should typically be used when
the SNR is lower than 13 dB.
Integer
normal (1)
high (2)
na (255)
Applicable to all un
*BurstMode
(*PerformanceParams 10)
Burst Mode Parameters.
Applicable to all units.
BreezeACCESS 4900 System Manual
197