User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*SpectrumAnalysisInformationSign
(*SpectrumAnalysisInformationEntr
y 3)
-
of signals alCount
Applicable to all units. Read
only. The number
(excluding OFDM frames)
detected in the channel.
Integer
*SpectrumAnalysisInformationSign
alSNR
(*SpectrumAnalysisInformationEntr
y 4)
-
NR
frames) detected in
Applicable to all units. Read
only. The approximate S
of the signals (excluding
OFDM
the relevant channel.
Integer
*SpectrumAnalysisInformationSign
alWidth
(*SpectrumAnalysisInformationEntr
y 5)
gnals
es)
levant
Applicable to all units. Read-
only. The average width in
microseconds of the si
(excluding OFDM fram
detected in the re
channel.
Integer
*SpectrumAnalysisInformationOFD
MFrames
(*SpectrumAnalysisInformationEntr
y 6)
Applicable to all units. Read-
only. The number of OFDM
frames received in the
relevant channel.
Integer
* MaxNumOfAssociationsLimit
(*AirInterface 19) T B
e limit for
Integer
AU-BS, AU-SA: If Data
Encryption is enabled, the
upper limit is 124. Otherwise
it is 512.
AUS-BS, AUS-SA: 5
BreezeNET B products
turn 65535.
Applicable to AU only. Not
applicable to BreezeNE
products. Shows th
the number of SUs that can
be associated with the AU.
re
*Disassociate
(*AirInterface 20)
Disassociation parameters.
*DisassociateAllSUs teger
cancelOperation (1),
disassociateAllSUs (2)
(*Disassociate 1)
Applicable to AU.
Disassociate ass SUs.
In
*DisassociateSuByMacAddress ress
(*Disassociate 2)
Applicable to AU.
Disassociate specified SU.
MacAdd
*TxControl
(*AirInterface 21)
Integer
on(1)
off (2)
Applicable to AU/BU.
Enables to turn the
transmitter Off and On. The
unit is reset automatically
upon configuration.
*LostBeaconsWa
(*AirInterface 22)
tchdogThreshold
ons before internal
refresh is performed.
ange: 100..1000 or ‘0’
A value of ‘0’ means that the
lost beacons watchdog is not
used and internal refresh is
not performed
Applicable to AU/BU.
The number of unsuccessful
consecutive transmissions
of beac
Integer
R
BreezeACCESS 4900 System Manual
187