User's Manual

Appendix E - Supported MIBS and Traps
MIB Parameter Description Value/Range
*SubBandUpperFrequency
e
z
the
z
(*FrequencyDefinition 2)
Applicable to SU/RB. Not
applicable to units with SW
version 2.0 or higher. The
lowest frequency in the
subset to be used for
scanning.
For 5.8 GHz products th
range is 5740 to 5830 MH
using a 10 MHz resolution.
For 4.9G Hz products
range is 4920 to 5080 MH
using a 10 MHz resolution.
For HW Revision C and
above this leaf is not
relevant - shall return 0.
Integer
*ScanningStep
(*FrequencyDefinition 3)
r
b-Bands only.
The scanning step to be
used for generating the
frequency subset.
Integer
mhz-5 (1),
Applicable to all units - Fo
flexible Su
For units with version 2.0
and above this is a read-
only parameter.
mhz-10 (2),
mhz-20 (3)
na (255)
*FrequencySubsetTable
(*FrequencyDefinition 4)
Applicable to all units. Not
accessible. The Frequency
Subset table that includes
he
wer Frequency
y the Scanning
all frequencies from t
Sub-band Lo
to the Sub-band Upper
Frequency, using steps as
defined b
Step
*FrequencySubsetEntry
(FrequencySubsetTable 1)
o all units. Not
the
Applicable t
accessible. An entry in
Frequency Subset table.
*FrequencySubsetTableIdx
(*FrequencySubsetEntry 1)
Applicable to all units. Read-
only. The index of an entry
in the Frequency Subset
table.
Integer
*FrequencySubsetFrequency
(*FrequencySubsetEntry 2) r
C
nc
ion
Frequency
Applicable to all units with
HW revision B and lowe
(for units with HW revision
and higher replaced by
*FrequencySubsetFreque
yNew to support a resolut
of 0.5 MHz). Read-only.
The frequency in MHz of an
entry in the
Subset table.
Integer
*FrequencySubsetActive
(*FrequencySubsetEntry 3)
Read-
of
al list of
frequencies to be used for
scanning.
active (1)
notActive (2)
Applicable to all units.
only. The status of an entry
in the Frequency subset
Table. Only frequencies
active entries will be
included in the fin
Integer
BreezeACCESS 4900 System Manual
180