User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*MaxTxPower
(*MaximumTransmitPowerEntry 4) smit
ATPC
ng
o the maximum
e
aximumTxPowerR
ange for the applicable
modulation level.
Applicable to SU/RB.
The maximum tran
power level that can be
either configured for the
*TxPower parameter or
reached by the
algorithm.
DisplayStri
Range: -10 t
defined by th
*DefinedM
*MaxNumOfAssociations
B
ted
A: 0-512 (0-124
cryption Option is
enabled).
AUS-BS, AUS-SA: 0-5.
na (65535)
(*AirInterface 10)
Applicable to AU. Not
applicable to BreezeNET
products. The upper limit for
the number of Subscriber
Units that can be associa
with the AU.
Integer
AU-BS, AU-S
if Data En
*BestAu
(*AirInterface 11)
Best AU/BU parameters.
Applicable to SU/RB.
*BestAuSupport
(*BestAu 1)
sm
)
enable (2)
na (255)
Applicable to SU/RB.
Disable/enable the Best
AU/BU selection mechani
Integer
disable (1
*BestAuNoOfScanningAttempts
(*BestAu 2)
Applicable to SU/RB. The
number of scanning
attempts to collect
information for the Best
AU/BU decision
Integer
1-255
*PreferredAuMacAddress
(*BestAu 3) dress of the
Mac Address
000000000000 means no
Applicable to SU only. The
MAC ad
preferred AU/BU (overriding
the Best AU/BU selection
process).
preferred AU
*NeighborAuTable
(*BestAu 4)
Not Applicable to SU/RB.
accessible. Neighboring
AUs/BUs table.
*NeighborAuEntry ble to SU only. Not
the
AUs table.
(*NeighborAuTable 1)
Applica
accessible. An entry in
Neighboring
*NeighborAuIdx
(*NeighborAuEntry 1)
Applicable to SU/RB. Read-
only. An Index of an entry in
the Neighboring AU/BU
Table
Range: 1…20
Integer
*NeighborAuMacAdd
(*NeighborAuEntry 2)
ead-
MAC Address Applicable to SU/RB. R
only. The MAC Address of
the AU/BU associated with
the entry in the Neighboring
AU/BU Table
*NeighborAuESSID
(*NeighborAuEntry 3)
community string
(Administrator Password).
DisplayString
Applicable to SU/RB. Read-
only. The ESSID of the
AU/BU associated with the
entry in the Neighboring
AU/BU Table. Accessible
only with the SNMP Write
*NeighborAuSNR
(*NeighborAuEntry 4)
Applicable to SU/RB. Read-
only. The average SNR at
which the SU/RB receives
the AU/BU associated with
the entry in the Neighboring
AU/BU Table.
Integer
Na (255)
BreezeACCESS 4900 System Manual
177