User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
breezeAccessVLMib
MIB Parameter Description Value/Range
*RunTimeESSID ly.
P
d).
SIZE(31))
characters.
(*ESSIDParameters 1)
Applicable to SU/RB on
The ESSID of the
associated AU/BU.
Accessible only with SNM
Write Community string
(administrator passwor
DisplayString (
Up to 31 printable case
sensitive ASCII
*MaximumCellDistance to all units. For
hen the
to
U of
teger
or units with SW
n
he range is 0 to
4 Kilometers.
0 means no compensation
slot size, maximal
t).
Applicable
In
(*AirInterface 2) AU/BU: read-write. For
SU/RB: read-only. The
distance is learned from the
AU/BU. In units with SW
version 2.0 and up -
applicable only w
Range: F
version bellow version 2.0
the range is 0 - 50000
Meters.
For units with SW versio
2.0 and up t
Cell Distance Mode is set
Manual. The highest
5
distance from the AU/B
any SU/RB served by it.
Affects the maximum time
the units wait for a response
(minimum
delay timeou
message and the slot size
by taking into account the
round trip propagation
delay.
*AIFS
ts.
e
in
Integer
Applicable to AU and SU.
(*AirInterface 3) Not applicable to
BreezeNET B produc
Arbitration Inter-Frame
Spacing (AIFS). This is the
number of time slots that
oneSlot (1)
twoSlots (2)
na (255)
define the DIFS.
(DIFS=SIFS+AIFS). A valu
of 1 should be used only
point-to-point applications to
allow one unit to have
advantage over the other
unit.
*WirelessTrapThreshol
(*AirInterface 4)
d
Applicable to AU/BU only. A
wireless link quality
threshold, expressed in % of
Integer
1-100 (%)
retransmissions, for sending
the
brzaccVLAUWirelessQuality
TRAP.
This trap indicate whether
the quality has gone below
or above the specified
threshold
*TransmitPowerTable
(*AirInterface 5) r
Applicable to all units. Not
accessible. Transmit Powe
parameters table.
*TransmitPowerEntry
Applicable to all units. Not
(*TransmitPowerTable 1) accessible. An entry in the
Transmit Power parameters
table.
*TransmitPowerIdx
(*TransmitPowerEntry 1)
-
le.
Integer
1-4
Applicable to all units. Read
only. An index of an entry in
the Transmit Power
parameters tab
BreezeACCESS 4900 System Manual
175