User's Manual

Menus and Parameters
Default value: 5 seconds.
4.2.6.2.13.2 Spectrum Analysis Scan Cycles
The Spectrum Analysis Scan Cycle is the number of scanning cycles when
Rang
Default value: 2 cycles.
4.2.6.2.13.3 nel Selection (AU only)
s weather the AU will choose the
best noise free channel upon startup after completion of the spectrum analysis
4.2.6.2.13.4 Spectrum Analysis Activation
The Spectrum analysis Activation option enables activation of the spectrum
will reset automatically and start-up
in spectrum analysis mode.
4.2.6.2.13.5
ctrum Analysis Information option enables resetting the spectrum
4.2.6. .13.6
nformation Display option enables viewing the results of
ormation includes the following details
OFDM frames with

performing Spectrum Analysis.
e: 1-100 cycles.
Automatic Chan
The Automatic Channel selection option define
process. The selection is per analysis: when the analysis is completed it will be
disabled automatically.
The default is Disable.
analysis process. Upon activation, the unit
Reset Spectrum Analysis Information
The Reset Spe
analysis counters.
Spectrum Analysis Information Display
The Spectrum Analysis I
2
the last analysis process. The displayed inf
for each channel:
 Frequency in MHz
 Signal Count: The number of signals (excluding OFDM frames with the
correct bandwidth) in the channel.
 Signal SNR: The approximate SNR of signals (excluding
the correct bandwidth) in the channel.
 Signal Width: The average width in microseconds of signals (excluding OFDM
frames with the correct bandwidth) in the channel.
OFDM Frames: The number of OFDM frames with the correct bandwidth
detected in the channel.
Operation and Administration
107