User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Menus and Parameters
Country Code Learning by SU is enabled, the SU will use the AU’s country code:
rived limitations will be forced and the following parameters
w country definitions:
(per modulation level) will be set to the maximum defined
t to the maximum modulation level defined by
l be set to enable if the country code supports burst mode,
and the burst duration will be set to default.
learning (adaptation) the unit is automatically reset. Before
this automatic reset, if the unit is running from the shadow version, the versions
ing version must be set as main. This is done to
the country code de
will be set according to ne
Maximum TX Power
by the country code.
TX Power (per modulation level) will be set to the maximum defined by the
country code.
The Modulation Level will be se
the country code.
The Multicast Modulation Level will be set to the minimum modulation level
defined by the country code.
The Burst Mode wil
After country code
must be swapped and the runn
avoid returning to the previous version, which occurs automatically after the
reset.
The default is Enable.
NOTE
The Country Code Learning by SU feature does not function with the default ESSID (ESSID1).
4.2.6.2.3.4
ing Show Frequency Definitions, the selected Sub-Band and
4.2.6.2.4 Frequency
4.2.6.2.4.1
ntry code supports two or more Sub-
and
Show Frequency definitions
Upon select
Frequency are displayed.
Definition Submenu in SU
Sub-Band Select
This parameter is available only if the cou
Bands. For information on how to view the Sub-Bands supported by the unit
the supported parameters’ values and options, refer to section 4.2.2.4
.
The range depends on the number of Sub-Bands supported by the country code
The default selection is Sub-Band 1.
.
Operation and Administration
95