User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Menus and Parameters
is for all associated SUs. In an SU, the Link Capability reports include
information on all AUs in the neighboring AUs table (all AUs with whom the SU
The Link Capability feature enables to adapt the configuration of the unit
sure optimal operation.
ility submenu includes the following options:
4.2.5.6.1 Show Link Capability-General
Select this option to view information on general parameters of relevant units. For
y its MAC address, the following details are
displayed:
HwVer: the hardware version of the unit.
CpldVer: The version of the Complex Programmable Logic Device (CPLD) used
ying the CPLD
r 4 digits country code supported by the unit. Currently this
SwVer: The SW version used by the unit. This parameter is available only in
n in the relevant AU.
unit. This parameter is available only in
4.2.5.6.2
view information on current wireless link parameters of
ach relevant unit, identified by its MAC address, the following
ation Option: Enable or Disable.
: Enable or Disable.
n Option: Enable or Disable.
nt AU.
can communicate).
according to the capabilities of other relevant unit(s) to en
The Link Capab
each relevant unit, identified b
in the unit. This parameter is available only in AUs, displa
version in the relevant SU.
Country: The 3 o
value is 1022.
SUs, displaying the SW versio
BootVer: The Boot Version of the
AUs, displaying the Boot version in the relevant SU.
Show Link Capability-Wireless Link Configuration
Select this option to
relevant units. For e
details are displayed:
ATPC Option: Enable or Disable.
Adaptive Modul
Burst Mode Option
Concatenatio
Country Code Learning by SU: Enable or Disable. This parameter is
available only in SUs, displaying the current option in the releva
Operation and Administration
89