Installation Manual

Subscriber Unit Installation Guide Initial Operation
BreezeCOM 23
9. Initial Operation
After completing the installation as described above, the system starts operation.
To verify correct operation, view the LED panel located on the bottom panel of
the Outdoor unit, as shown in Figure 14.
L
M
H
ETH
WLNK
PWR
Figure 14. Outdoor Unit LEDs
The following table lists the various LED states.
Name Description Functionality
PWR Power supply On – After successful power up
Off – Power off
WLNK Synchronization Off – No Synchronization
On – Synchronization with Access unit
ETH Ethernet activity Blinking – Reception of data from Ethernet LAN
Off – No reception of data from Ethernet LAN
QLT Quality of
received RF
signal
very low quality reception or not
synchronized with Access Point less than
-81 dBm
low quality reception (usually enabling
1Mbps traffic) from -81 to -77 dBm
medium quality reception (usually enabling
2 Mbps traffic) from -77 to -65 dBm
high quality reception (usually enabling 3
Mbps traffic) greater than -65 dBm