Installation Manual

Installing the Indoor Unit Subscriber Unit Installation Guide
14 BreezeCOM
spare. Connect the Baseband cable to the Radio connector, located on the
front panel of the Indoor unit shown in Figure 8.
3. Connect the power cord to the unit’s port connector, located on the rear panel
shown in Figure 7. Connect the other end of the power cord to the AC mains.
Note: Prepare the other end of the power cord with a power plug appropriate
to the country in which the unit is being installed. The color codes of the
cable are:
brown phase ~
blue neutral 0
yellow/green grounding
The factory set voltage of the Indoor unit is marked appropriately on the
rear panel of the unit.
POWER
100-120VAC
207-253VAC 250mA
500mA
Figure 7. Indoor Unit Rear Panel
4. Verify that the LED, located on the rear panel, is ON indicating that the 48
VDC is not shorted.