Installation Manual

Subscriber Unit Installation Guide Installing the Indoor Unit
BreezeCOM 13
1. If you are installing an SU-O series, connect the antenna cable between the
Outdoor unit and the antenna.
2. Connect one end of the ground cable to the Outdoor unit bottom panel and
connect the other end to a good ground connection.
3. Connect the Indoor unit to Outdoor unit Baseband cable, supplied with the
access unit, to the appropriate connector. Appendix A provides instructions on
how to prepare this cable.
6. Installing the Indoor Unit
1. Remove the wall mounting bracket clipped to the rear of the Indoor unit and
mount the Indoor unit on a wall as shown in Figure 6.
Figure 6. Wall Mounting the Indoor Unit
2. According to specific conditions, route the Outdoor unit to Indoor unit
Baseband cable into the house/office so that it shall conveniently reach the
Indoor unit in such a way as to ensure minimal interference, leaving some