Installation Manual

Installing the Outdoor Unit - SU-A Series Subscriber Unit Installation Guide
12 BreezeCOM
5. Installing the Outdoor Unit - SU-A Series
Note: All SU-A Outdoor units are supplied with a sun-guard assembled on the
rear panel of the unit.
The SU-A Outdoor unit should be installed on a pole to allow optimal alignment.
Use the installation holes (see Figure 3) to pole mount the unit using one of the
following options:
• U-bolt - size A (inside installation holes, up to 2" pole)
• U-bolt - size B (outside installation holes, up to 3" pole)
• Metal bands
5.1 Connecting the Baseband, Antenna (SU-O) and Ground Cables
The Baseband and Ground cable connectors are located on the bottom panel of the
Outdoor unit, shown in Figure 4. The Antenna connector is located on the top
panel of the SU-O series Outdoor unit, shown in Figure 5.
L
M
H
ETH
WLNK
PWR
INDOOR MON
Figure 4. Outdoor Unit Bottom Connection Panel
ANT. 2
Figure 5. Outdoor Unit (SU-O) Top Connection Panel