Installation Manual

Installation Guidelines Subscriber Unit Installation Guide
8 BreezeCOM
3.1 Installation Overview
Note: It is highly recommended to complete configuration of the system
parameters in a lab prior to the installation. Refer to page 17 for
instructions on these settings.
The typical installation scheme is depicted in Figure 2. The installation process
should follow these general steps:
1. Mount the Outdoor unit. If you are installing an SU-O series, mount an
external antenna (not supplied by BreezeCOM). Connect the Outdoor unit to
the antenna (SU-O series only). Connect the Baseband and ground cables to
the Outdoor unit.
2. Mount the Indoor unit. Connect the Baseband cable (from the Outdoor unit).
Connect the Indoor unit to the AC mains via the power cable.
3. Verify optimal antenna positioning.
4. Verify connectivity to the Base Station.
5. Connect the Indoor unit Ethernet connector to the user’s network/PC using an
Ethernet Cable (a straight cable for connecting SU-A/O 1D or SU-A/O 1D1V
to a PC, or for connecting SU-A/O BD or SU-A/O 8D to a hub).
6. Connect the telephone cord to the voice port and the POTS (DV products).
7. Connect an ASCII terminal to the MON port of the Outdoor unit(s) via the
technician cable and configure basic system parameters.
Note: The Indoor unit should be connected to the power source only after the
Outdoor unit have been connected to it.