Installation Guide

Access Unit Installation Guide Configuring System Parameters

BreezeCOM 19

6.6 Initial Operation

After completing the installation as described above, and after connecting the

Indoor unit to the AC Mains, the system starts operation. To verify correct

operation, view the LED panel located on the bottom panel of the Outdoor unit, as

shown in Figure 13.

ETH

WLNK

PWR

Figure 13. Outdoor Unit LEDs

Table 1 lists the various LED states.

Table 1. Outdoor Unit LEDs

Name Description Functionality

PWR Power supply On – After successful power up

Off – Power off

WLNK Not used

ETH Ethernet activity Blinking – Reception of data from Ethernet LAN

Off – No reception of data from Ethernet LAN

LOAD Active subscriber

units no subscribers

1-8 subscribers

9-16 subscribers

17 or more subscribers