Installation Guide
Access Unit Installation Guide Configuring System Parameters
BreezeCOM 15
The following system parameters must be configured for each specific installation:
• IP Address
• Subnet Mask
• Default Gateway Address
• ESS ID
• Antenna Diversity
The unit’s factory default access rights setting is Installer to allow configuration of
system parameters.
Note: You should select Reset Unit in the Station Control Sub-menu for the
changes to take effect.
6.2 IP, Subnet Mask and Default Gateway Address Configuration
1. After connecting the ASCII terminal to the Outdoor unit, press Enter to obtain
the BreezeACCESS Monitor main screen.
BreezeACCESS (AU-A/O)
Official Release Version - 1.3.5
Release Date: Wed Apr 28 16:23:57 1999
BreezeACCESS Monitor
=====================
1 - System Configuration
2 - Advanced Settings
3 - Site Survey
4 - Access Control
BreezeACCESS >>>
Figure 9. Breeze Access Monitor Main Menu