Installation Guide

Access Unit Installation Guide Installing the Indoor Unit
BreezeCOM 13
Note: Prepare the other end of the power cord with a power plug appropriate
to the country in which the unit is being installed. The color codes of the
cable are:
brown phase ~
blue neutral 0
yellow/green grounding
The factory set voltage of the Indoor unit is marked appropriately on the
rear panel of the unit.
POWER
100-120VAC
207-253VAC 250mA
500mA
Figure 7. Indoor Unit Rear Panel
4. Verify that the LED, located on the rear panel, is ON indicating that 48 VDC is
not shorted.
RADIO10-BASE-T
Figure 8. Indoor Unit Front Panel