Installation Guide

Installing the Indoor Unit Access Unit Installation Guide
12 BreezeCOM
5. Installing the Indoor Unit
1. Remove the wall mounting bracket clipped to the rear of the Indoor unit and
mount the Indoor unit on a wall as shown in Figure 6.
Figure 6. Wall Mounting the Indoor Unit
2. According to specific conditions, route the Outdoor unit to Indoor unit
Baseband cable into the building so that it shall conveniently reach the Indoor
unit in such a way as to ensure minimal interference, leaving some spare.
Connect the Baseband cable to the Radio connector, located on the front panel
of the Indoor unit shown in Figure 8.
3. Connect the power cord to the unit’s port connector, located on the rear panel
shown in Figure 7. Connect the other end of the power cord to the AC mains.