Installation Guide

Installing the Outdoor Units Access Unit Installation Guide
10 BreezeCOM
4.2 Mounting the Antenna
Secure brackets to the antenna using screws, lock washers and nuts as appropriate.
Mount the antenna on a pole and secure it using metal bands or U-bolts. Do not
tighten the metal bands or U-bolts, in order to enable rotation of the antenna over
the horizontal plane. The front of the antenna should be directed towards the Base
Station/Access Unit. Use Vertical Polarization.
The AU-O Outdoor unit comes with a sun-guard mounted on its rear side. This
accessory can be removed by unscrewing the attaching screws, and can be installed
on the front side if necessary. A second, optional sun-guard can be ordered for
assembly on the front cover. The second sun-guard is recommended for
installations where both the front and the back of the Outdoor unit may be exposed
to direct sunlight. Contact your BreezeCOM representative for a parts catalog with
the accessories that you can order.
4.3 Wall Mounting the Outdoor Unit
See the instructions included with the wall mounting kit.
4.4 Connecting the Baseband, Antenna and Ground Cables
The Baseband, Ground and Monitor cable connectors are located on the bottom
panel of the Outdoor unit, shown in Figure 4. The Antenna connectors are located
on the top panel of the Outdoor unit, shown in Figure 5.
L
M
H
ETH
WLNK
PWR
INDOOR MON
Figure 4. Outdoor Unit Bottom Connection Panel