Operation Manual

9
Chapter 3: Conguration
Go to next
screen
Notes
1.
Select the MMI
language
Device is running
as a Wireless
Client.
ScreenshotInstructions
2.
3.
There are three modes of network conguration for AIRMM02F. It can be a
wireless client, a wired client, or even a wireless access point (Wireless AP).
3.1 Congure as an Wireless Client
The factory default mode is the client Mode. According to the availability
of an Ethernet cable, the device will automatically select a suitable client
mode to operate. User can also manually change the setting of network
conguration through the Setup menu “Setup/Advanced Setup/Congure
Network”.
If there is an existing 802.11b/g wireless network in your home, this will
be simplest mode to connect AIRMM02F to the existence network.
User just have to power on the device, with no Ethernet cable plugged
in, the device will automatically go into the wireless client mode and
look for all available wireless APs (Access Points). To connect for the
rst time, you will need to select the AP to connect and set the correct
encryption key. Once the setting is nished, the device will save the
related settings and connect to the designated AP when it is power on.
However, if there is problem connecting to the designated AP, the device
will show the AP list screen for user to congure again.
First time using device without an Ethernet cable plugged in:
Initial screenAluratek
“►” button or
“OK” button or
press the right
rotary wheel.
“►” button or
“OK” button or
press the right
rotary wheel.