Product Manual

Step 2: Install hitch ball(s) to adjustable section. See pin assembly below.
Note: You can tow with one or both hitch balls installed.
a. Align the hitch ball hole with the
center of the bracket hole
Step 1: Install Aluminum Drop Section to Hitch Receiver with Locking Hitch Pin. The two locking pins supplied are keyed
alike and are exactly the same (This section can be inserted as a drop (as shown) or it can be reversed and used as a rise
with no change in the towing weight ratings)
ATTENTION:
• Be aware and follow all listed gross trailer weight and tongue weight ratings and do not exceed towing ratings
before and during use or serious injury and damage to your trailer/vehicle could occur.
• The maximum weight resting on the trailer tongue should be no more 10% of ball rating (if the ball is rated at
12,000 lbs. the tongue weight should not exceed 1,200 lbs.)
• Ensure all hitch locks are securely fastened during installation before towing
INSTALLATION GUIDE
Step 3: After installing hitch balls to adjustable section. Slide the adjustable section onto the aluminum drop at
desired height and secure with the locking hitch pin and standard hitch pin. ALWAYS use both pins to secure
adjustable section to the drop.
b. Insert the hitch ball securing pin completely through the center of the balls that you will be using until they are
flush to the end of the adjustable section. The Aluma-Tow can be used with either one or two hitch-balls installed.
RATINGS AND TOWING CAPACITY
Max tongue weight: 1,200 lbs.
1-7/8” ball : 5,000 lb. GTWR
2” ball : 7,500 lb. GTWR
2-5/16” ball : 12,000 lb. GTWR
Independently tested to meet or exceed
J684 towing standards
Questions? Contact Us: Toll Free: 1-800-545-9633 | [e-mail] | www.alumatow.com | Uriah Products LLC, Springfield MO