User manual

Customization
An explanation of the Customization parameters is given in the table below:
Parameter Explanation
Login Failures Allowed: sets the number of consecutive failed login attempts
that are permitted from a remote computer.
Timeout: sets the amount of time a remote computer must
wait before attempting to login again after it has exceeded
the number of allowed failures.
Working Mode If Stealth Mode is enabled, the KN9116 cannot be pinged.
Reset on exit Placing a check here causes the KN9116 to reset itself and
implement all the new changes when you log out. Following
the reset, wait approximately 30 to 60 seconds before
logging back in.
For example, if you change the IP address in the Network
dialog box, you must open this page and enable Reset on exit
before logging out. Otherwise, the change will not take effect.
Reset Values Clicking this button undoes all changes that have been made
to the Configuration and Administration pages (except for the
Port Names that were assigned to the Ports - see Set Ports,
p. 21) and returns the parameters to the original factory
default settings (see Factory Default Settings, p. 69).
Clear Name List This function is similar to Reset Values. The difference is that
it also clears the Port Name settings at the same time that it
undoes all changes and returns the setup to the original
factory default settings.
2004-11-23
20