User manual

Installation
To set up your KN9116 installation refer to the diagram below (the numbers in
the diagram correspond to the numbered steps), and do the following:
1. Plug your keyboard, mouse, and monitor into the unit’s Console Ports.
2. Use KVM cable sets (as described in the Cables section on p. 4), to connect
any available CPU Port to the Keyboard, Video and Mouse ports of the
computer you are installing.
3. Plug the cable from the LAN or WAN into the KN9116’s RJ-45 socket.
4. Plug the female end of the power cord into the KN9116’s Power Socket;
plug the male end into an AC power source.
5. Turn on the power to the KN9116.
After the KN9116 is powered up, you can turn on the computers.
1. Make sure that power to all the devices you will be connecting up
have been turned off. You must unplug the power cords of any
computers that have the Keyboard Power On function.
2. To prevent damage to your installation, make sure that all devices
on the installation are properly grounded.
4
5
3
1
2
2004-11-23
8