User manual

2. Reset Switch

M Pressing and holding this switch in while powering on the KN9116

restores the switch to the factory installed firmware version.

M Pressing and holding this switch in for more than two seconds performs a

system reset.

Note: This switch is recessed and must be pushed with a thin object - such

as the end of a paper clip, or a ballpoint pen.

3. Link LED

Flashes GREEN to indicate that a Client program is accessing the device.

4. 10/100 Mbps Data LED

M The LED lights ORANGE to indicate 10 Mbps data transmission speed.

M The LED lights GREEN to indicate 100 Mbps data transmission speed.

5. Power LED

Lights when the KN9116 is powered up and ready to operate.

6. Port Switching Buttons

M Press Port DOWN to switch from the current port to the previous port on

the installation.

M Press Port UP to switch from the current port to the next port on the

installation.

2004-11-23