User manual

Note: 1. The Port number that corresponds to a unit’s IP address is set by the
Administrator on the Network configuration page (see p. 16 for
details).
2. Clicking the Refresh button causes the utility to rescan the local LAN
segment for KN9000 devices.
3. If the utility fails to connect to a unit that you specified, it assigns
another free IP address (if one exists), to that device and attempts to
connect again.
4. When the Administrator Utility searches for KN9000 devices, if it
finds them in different network segments (one at 10.0.0.xxx, and
another at 216.0.0.xxx, for example), it will attempt to substitute a
dynamic IP address (10.0.0.111, for example).
Logging In
Once the Administrator Utility connnects to the unit you specified, a login
window appears:
Only those who have Configuration privileges (see User Management;
Permissions, p. 22) are allowed to log in.
Provide a valid Username and Password, then Click Login to continue.
Note: The default Username is administrator; the default Password is
password. You can change these to whatever you prefer (see User
Management, p. 21) after you have logged in.
2004-05-04
11