Instruction manual

20
Dip Switch Default Settings
1 - OFF
2 - ON
3 - OFF
4 - OFF.
Dip Switch Description
Switch 1 is used for firmware selection. Switch 1 is set to the ON position to
load the factory default firmware. If you set this switch to the OFF position
with no user firmware loaded, the boot program loads the factory firmware.
Switch 1 is set to OFF by default.
Switch 2 is used to accept the new IP address from the administrator utility
software. Switch 2 is set to the ON position by default.
Switch 3 is used to either: limit KN9000 access to software with a matching
serial number (software provided in the same package) or provide access to
software regardless of a matching serial number (software distributed with
another KN9000 unit). Switch 3 is set to the OFF position by default, to allow
KN9000 access to software regardless of the software serial number. If you
set this switch to the ON position, the KN9000 limits access to the software
with the matching serial number (software provided in the same package as
the KN9000 unit).
Switch 4 is reserved for future applications.