User manual

Chapter 5. The User Interface

3. Click Record.

The dialog box disappears, and a small panel appears at the top left of the

screen:

4. Press the keys for the macro, then click Done.

Note: To pause macro recording, click Pause. To resume, click Pause

again.

You return to the Macros dialog box with your system macro key presses

displayed in the Macro column:

If you want to change any of the keystrokes, select the macro and click

Edit.

5. Repeat the procedure for any other macros you wish to create.

Once the system macros have been created, they are available for use on a

port-by-port basis. They get selected on a port’s Connection page (see Exit

Macro, page 92, for details).

Note: 1. You can choose only one system macro per port.

2. Systems macros are stored on the switch, therefore macro names may

not exceed 64 Bytes; hotkey combinations may not exceed 256 Bytes;

each key usually takes 3–5 Bytes.

kn2124v-4132.book Page 61 Thursday, June 25, 2009 11:27 AM