User manual

Chapter 9. AP Operation
101
(Continued from previous page.)
Item Description
Server This area is used when you want to connect to a KN2108 / KN2116
at a remote location.
 You can drop down the IP list box and select an address from the
list.
 If the address you want isn't listed, you can key in the IP address
of your target, then key in the Port number in the Port field. (If
you don't know the Port number contact the Administrator.)
 When the IP address and Port number for the target unit have
been specified, click Connect to start the connection.
 When you have finished with your session, click Disconnect to
break the connection.
Message List Lists status messages regarding the connection to the KN2108 /
KN2116.
Switch to Remote
View
Once contact with a KN2108 / KN2116 has been established, this
button becomes active. Click it to switch and take over console
control of the unit that is attached to the KN2108 / KN2116.
The screen output of the unit appears on your monitor. Your
keystrokes and mouse movements are captured and sent to the
KN2108 / KN2116 to be executed on the attached unit.
If the KN2108 / KN2116 is connected to a KVM switch, you can
control the switch and the computers connected to it just as if you
were connected locally.
Change
Password
This button becomes active after a connection to a KN2108 /
KN2116 has been established. It allows the User to change the
password he logs onto the KN2108 / KN2116 with.
kn2116.book Page 101 Thursday, July 10, 2008 4:05 PM