User manual

KN1000 User Manual
10
Components
Front View
No. Component Description
1 LAN Port The Cat 5e cable that connects the KN1000 to the LAN, WAN,
or Internet plugs in here.
2Firmware
Upgrade/Reset
Switch
1. Pressing and releasing this switch performs a KN1000
system reset. (See Erratic operation, page 166.)
2. Pressing and holding this switch for more than three
seconds returns the KN1000 to its factory default
configuration settings.
3. Pressing and holding this switch while powering on the
switch returns the KN1000 to its factory default firmware
level. This operation should only be performed in the event
of a firmware upgrade failure that results in the device
becoming inoperable.
Note: This switch is recessed and must be pushed with a thin
object - such as the end of a paper clip, or a ballpoint pen.
3 10/100 Mbps
LED
The LED lights ORANGE to indicate 10 Mbps data
transmission speed. It lights GREEN to indicate 100 Mbps
data transmission speed.
4 Link LED Flashes GREEN to indicate that a Client program is accessing
the device.
5 Power LED Lights ORANGE when the KN1000 is powered up and ready
to operate.
6 Power Outlet
LED
Lights ORANGE when the server attached to the KN1000’s
power outlet is powered on
12345
6