User manual

Chapter 3. Administrator Utility
53
The upper section of the Port Management page is used to manage port access
rights for users and groups. The boxes on the left side of the page show all users
and groups that have been created. The boxes on the right side of the page
govern port access rights. These boxes are discussed in the table below.
In the middle of the page are six sets of arrows. Each set contains two arrows:
one facing leftward (<) and the other facing rightward (>), which correspond
to the boxes immediately to the left and right, respectively. Arrows are used to
move users and groups from the boxes on the left into the boxes on the right
and vice versa.
Note: 1. You cannot add more than 32 users and 32 groups to a port. If you
need to add more than 32 users to a port, first add the users to groups
and then add those groups to the port.
2. If a user is granted both user and group access rights to the same port,
the user access rights will be applied and not those of the group.
Box Name Description
Available Users All KM0832 Users listed in this box do not yet have permission
to access the port. Although Super Administrators and
Administrators also are listed here, they already have full access
and do not need to be added to the ports.
Available Groups All KM0832 groups are listed by group name in this box. Groups
listed in this box do not have permission to access the port.
No Access Users Users who are restricted from access to the port. Administrators
can move certain users here to prevent others from accidentally
granting port access to them. If a User in this box is a member of
a group that has permission to access the port, placing the user
in this box restricts the user from accessing the port.
View Only Users Users who are only permitted to view video from the port.
Full Access Users Users who are permitted both to view video from the port and to
control the port. If a cascaded station is in the port, the User will
not be able to access the ports of that station until granted
access rights to the individual ports.
No Access Groups Groups which are restricted from access to the port.
Administrators can move certain groups here to prevent others
from accidentally granting port access to them.
View Only Groups Groups which are only permitted to view video from the port.
Full Access Groups Groups which are permitted both to view video from the port and
to control the port. If a cascaded station is in the port, the Group
will not be able to access the ports of that station until granted
access rights to the individual ports.