User manual

KM0216 / KM0432 User Manual
54
Hotkey Beeper Control
The Beeper (see ACTIVATE BEEPER, page 43) can be Hotkey toggled On and
Off. To toggle the Beeper, key in the following Hotkey combination:
1. Invoke HKM (see page 49).
2. Press [B]
After you press [B], the Beeper toggles On or Off. The Command Line displays
Beeper On or Beeper Off for one second; then the message disappears and you
automatically exit HKM.
Hotkey Summary Table
[Num Lock] + [*]
or
[Num Lock] + [-]
[Port ID] [Enter] Switches the KVM focus to the computer
that corresponds to that Port ID.
[T] [n] [Enter]
Sets the Auto Scan interval to n seconds
–
where n is a number from 1–255.
[A] Invokes Auto Scan Mode.
When Auto Scan Mode is in effect, press
[P] or left-click the mouse to pause Auto
Scanning.
When Auto Scanning is paused, press any
key or left-click the mouse to resume Auto
Scanning.
[←] Invokes Skip Mode and skips from the
current port to the first previous accessible
port.
[→] Invokes Skip Mode and skips from the
current port to the next accessible port.
[↑] Invokes Skip Mode and skips from the
current port to the last accessible port of
the previous station.
[↓] Invokes Skip Mode and skips from the
current port to the first accessible port of
the next station.
[B] Toggles the beeper on or off.
km0216-0432.book Page 54 Wednesday, April 14, 2010 3:17 PM