User manual

Chapter 4. Keyboard Port Operation
51
Auto Scanning
Auto Scan switches among all the KVM ports that are accessible to the current
Operator at regular intervals (see SCAN/SKIP MODE, page 41, for information
regarding accessible ports). This function is convenient for automatically
monitoring the activity of the computers on the installation.
Setting the Scan Interval
The amount of time Auto Scan dwells on each port is set with the Scan
Duration setting of the OSD F3 SET function (see SCAN DURATION,
page 41). You can change the scan interval before activating Hotkey Auto
Scanning, if you wish, with the following Hotkey combination:
1. Invoke HKM (see page 49).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1–255 that represents
the number of seconds for the dwell time.
The letter T and the numbers display on the Command Line as you key
them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit HKM, and are ready to
invoke Auto Scanning.
km0216-0432.book Page 51 Wednesday, April 14, 2010 3:17 PM