Instruction manual

Removing the Keyboard and Touchpad
The keyboard and touchpad can be easily removed for repair or maintenance.
To remove the keyboard and touchpad module, do the following:
1. Turn off the power to the KL0116. (It isn’t necessary to power off any of
the attached equipment.)
2. Remove the two attaching screws.
3. Locate the opening toward the front and center of the the unit’s bottom
panel. The bottom of the keyboard and touchpad module is visible through
the opening.
4. Push up on the bottom of the keyboard and touchpad module until it
releases from the chassis.
5. Lift the module clear and unplug the cables.
After you have reinstalled the module, simply power up the KL0116 and you
are ready to go to work.
2003-07-25
53