Instruction manual

Chapter 6.

Remote Console Operation

The KL0116 can be controlled from an independent remote KVM console up

to 500 feet (150 meters) away when used in combination with the ALTUSEN

KA9250 Remote Console Station.

Installation

Installation simply consists of plugging cables into their appropriate ports. Re-

fer to the installation diagram on the next page as you do the following steps:

1. Plug the keyboard, monitor, and mouse cables for the remote console

devices into their ports on the Console side of the KA9250.

2. Plug one end of the Category 5E cable into the KA9250’s Remote I/O port.

Plug the other end of the cable into the KL0116’s Remote Console port.

Note: To assure optimum video quality Category 5E (Enhanced Category

5) or Category 6 cable with solid conductors should be used.

Standard patch cables are adequate for shorter distances, but not for

long distances, such as 500 feet. For additional cable information,

contact your dealer.

3. A power adapter is supplied with the KA9250. Plug the power adapter cable

into the KA9250’s Power Jack; then plug the power adapter into an AC

source.

4. Power up your KL0116 installation according to the procedures given under

step 5 on page 13.

Before you begin, make sure that the KL0116 is either powered off,

or that it is set to Local Console operation (the KL0116’s Local Con-

sole LED is on).

2003-07-25