Instruction manual

F7 SCAN:
The SCAN function (Auto Scanning) automatically switches the KVM focus
among User-selected computers at regular intervals in order to monitor their ac-
tivity without having to switch manually.
w The selection of computers to be included for Auto Scanning is made with
the Scan/Skip Mode setting under the F3 SET function (see p. 30).
w The amount of time that the focus stays on each Port is set with the Scan
Duration setting under the F3 SET function (see p. 29).
w As each computer is accessed, the letter S appears in front of the Port ID
display to indicate that it is being accessed under Auto Scan Mode.
w While you are in Auto Scan Mode, you can pause the scanning in order to
keep the focus on a particular computer either by pressing P, or with a Left
Click of the mouse. To resume scanning, press any key or Left Click, again.
See Invoking Auto Scan, p. 20, for details.
w To stop scanning and stay at a particular location, press the [Spacebar] to
exit Auto Scan Mode. If the scanning stops on an empty port, or one where
the computer is attached but is powered Off, the monitor screen will be
blank, and the mouse and keyboard will have no effect. Simply wait - after
the Scan Duration time is up, the Scan function will move on to the next
port.
w While Auto Scan Mode is in effect, ordinary keyboard and mouse functions
are suspended You must exit Auto Scan Mode in order to regain normal
control of the console.
w To exit Auto Scan Mode, press the [Spacebar] or [Esc].
2003-07-25
36