Instruction manual

Two LEDs are built into each selection switch. The one on the left is the On
Line LED; the one on the right is the Selected Port LED:
w An On Line LED lights GREEN to indicate that the device attached to
its corresponding port is up and running.
w A Selected LED lights AMBER to indicate that its corresponding port is
the one that has the KVM focus. The LED is steady under normal
conditions, but flashes when its port is accessed under Auto Scan Mode
(see F7 SCAN, p. 36).
w Each time the KL0116 is powered on, the On Line and Selected LEDs
blink in sequence as the Switch performs a self-test.
4. Keyboard
Note: The special functions for the F6, F9, F10, F11, and F12 function
keys as well as the Esc and Z keys (the functions that are enabled
when the Fn key is held down), are not supported at this time.
5. Touchpad
6. Power LED
Lights BLUE to indicate that the unit is receiving power.
7. Console Release
The KL0116 has a mechanism that locks it in the “In” position to prevent it
from accidentally sliding out. To slide the console out, push this tab
sideways.
8. Rack Mounting Brackets
There are rack mounting brackets attached to each corner of the unit. They
are used to secure the chassis to a system rack.
2003-07-25
7