User's Manual

Created by Allremote Wireless Technology 2005/8/10 2
b. If duplicate failed, please repeat 1, 2, 3, step.
c. The each buttons of RRC001A, can copy each individual variety code.
＊ In normal state, press down RRC001A any key, it will launch 300MHZ; 310MHZ and
390MHZ take turns in 3 frequency, if want to launch second time, have to release
the button and start over again.
A. For Genie

Intellicode / GMI-3BL

Garage Door Remote Controls (programming
applicable to buttons 1, 2, 3 and 4)
A 1. Entering Program Mode: Press the #1 and #3 buttons on the RRC001A
simultaneously. You will notice a series of flashes from the RRC001A
LED indicator: it will flash
three times, stop, and then flash twice. You have now entered the Programming Mode.
A 2. Programming RRC001A with Genie

Intellicode / GMI-3BL

Remote Transmitter:
Place the RRC001A
Press and hold button #1 (or any other buttons) on RRC001A and
activate the button on the Source Remote. The LED indicator on the RRC001A will flash
rapidly, then it will slow to a steady light. When the RRC001A has synchronized with the
Source Remote, the LED indicator will go off.
A 3. Exit Programming Mode: Again press the #1 and # 3 buttons on the RRC001A
simultaneously. The LED indicator will flash once to confirm that you have exited the
Programming Mode.
Note: Especially for the well-known brand “Genie

Intellicode/ GMI-3BL

” only product,