Rack Mount Power Supplies Installation Guide Models Include: VertiLine33D - 12VDC @ 8 amp - Sixteen (16) PTC protected outputs VertiLine33TD - 12VDC @ 16 amp - Sixteen (16) PTC protected outputs VertiLine63D - 24VDC @ 8 amp - Sixteen (16) PTC protected outputs VertiLine63TD - 24VDC @ 16 amp - Sixteen (16) PTC protected outputs Rev. 090810 More than just power.
Overview: Altronix VertiLine Rack Mount Power Supplies provide sixteen (16) filtered and electronically regulated power outputs in a space saving 1U EIA 19” rack mount chassis. The units are available with either 12VDC or 24VDC power outputs. Vertiline Rack Mount Power Supplies are also available with eight (8) outputs. Specifications: Features: Agency Listing: • CE European Conformity. Input: • 115VAC 60 Hz. Output: • Filtered and electronically regulated outputs.
10. The power LEDs on the faceplate for Outputs 1-8 will illuminate when AC power is present (Fig. 1a, pg. 4). Note: If any of the power LEDs are not illuminated, the cause may be due to the following: a. AC mains fail. b. Illuminated master power disconnect circuit breaker is OFF or tripped. c. One (1) or more power output PTCs are tripped due to a short circuit or overload condition. To reset the PTC: 1. Set illuminated master power disconnect circuit breaker to the (OFF) position (Fig. 1c, pg. 4).
-4- Vertiline33D/VertiLine33TD/Vertiline63D/VertiLine63TD 1e Removable Terminal Block. 1d IEC 320 Connector: 115VAC 60Hz (grounded line cord included). 1c Illuminated master power disconnect circuit breaker (switch): • OFF position Circuit breaker tripped Switch not illuminated. • RESET (ON) position Switch illuminated. 1b Power Outputs: 12VDC or 24VDC. 1a LED(s) 1-8: Power LED indicators.
Vertiline33D/VertiLine33TD/Vertiline63D/VertiLine63TD -5- Fig.
The lightning flash with arrow head symbol within an equilateral triangle is intended to alert the user to the presence of an insulated DANGEROUS VOLTAGE within the product’s enclosure that may be of sufficient magnitude to constitute an electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Chassis Mounting Options: Rack Mount Installation 1. Remove factory installed screws from both sides of rack chassis (Fig. 3a). 2. Attach mounting brackets (A) on the left and right side of rack chassis using the two (2) flat head screws (B) (included) (Fig. 3b). 3. Install unit into desired EIA 19” rack position and secure with mounting screws (not included) (Fig. 3c). Fig. 3 Fig. 3b Fig. 3a Top Fig. 3c Top Top Front Left Front Left Front Left B Remove A Wall Mount Installation 1.
Notes: Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 web site: www.altronix.com, e-mail: info@altronix.com. Lifetime Warranty, Made in U.S.A.
