Installation Guide

TSH Kits D - 3 -
T2SK7F8D: Configuration of Software House iSTAR Ultra Boards
1. Align the Software House boards on the backplane to match the boards’ mounting holes with corresponding pems.
2. Fasten standoffs (provided) to pems that match the hole pattern for Software House iSTAR Ultra GCM, iSTAR Ultra ACM, and /or
I8, R8, I8-CSI boards (Fig. 2, 2a, pg. 3).
3. Mount Software House boards to standoffs utilizing provided 5/16” pan head screws (Fig. 2a, pg. 3).
Note: Software House iSTAR Ultra ACM boards have one (1) USB port each.
Please orient the board in the appropriate position according to the Fig. 2 below.
4. Fasten backplane to Trove2 enclosure utilizing lock nuts (provided).
Software House
I8, R8 or
I8-CSI
Module
Software House
iSTAR Ultra GCM
Software House
iSTAR Ultra ACM
USB PORT
Altronix
eFlow104NB
Altronix
VR6 & PDS8CB
Altronix
ACM8CB
RSB2 Bracket
Rocker Switch
Pem
Standoff
Power Supply or
Sub-Assembly
Backplane
Pan Head
Screw
Fig. 2a
Fig. 2