Installation Instructions

- 4 - Trove SALTO ULXB Kits Installation Guide
T2SAK78: Configuration of SALTO Modules:
1. Fasten spacers onto metal pems configuration (A) of backplane (Fig. 3, pg. 4).
2. Position SALTO modules over corresponding spacers and mount them utilizing pan head screws (provided) (Fig. 3a, pg. 4).
3. Mount backplane to enclosure with hardware.
Access Controller Position Chart for the Following Models:
SALTO Access Controller Pem Mounting
CU42E0, CU4200 or CU4EB8
A
Fig. 3
OUT1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8
Common Power Outputs (NEG)
P
N
+ INP1 - + INP2 -
PWR1+
PWR2+
COM(-)
PWR2+
COM (-)
P
N
Fuse1
Fuse2 Fuse3 Fuse4 Fuse5 Fuse6 Fuse7 Fuse8
IN1 Fuse
IN2 Fuse
PWR1+
1 2 3 4 5 6 7 8
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
CONTROLLER
ACCESS POWER
IN GND IN GND IN GND IN GNDIN GND IN GND IN GND IN GND
ACM8
1 2 3 4
5 6 7 8
INPUT
TRIGGER
10A 250V
+INP- T + RET-
NO C NC
FACP INTERFACE
Power Control
- + - +
F1 F2 F3 F4 F5 F6 F7 F8
MAIN
TRG
FACP
1 2 3 4
1 2 3 4
ON
ON
1 2 3 4
1 2 3 4
ON
ON
Altronix
ACM8
A A
A A
Altronix - PDS8
Altronix VR6 is mounted under PDS8
L
G
N
BAT FAIL
AC FAIL
NC
C
NO NC
C
NO
AC
DC
- BAT +
+ DC -
AC DELAY
Altronix
AL1024ULXB2
Pem
Spacer
HS4 Module
Backplane
Pan Head Screw
Fig. 3a