Spec Sheet

Description
Altronix T2CVK7F10 kit consists of Trove2 enclosure, TCV2 CDVI/Altronix backplane
with one (1) 24VDC @ 10A power supply/charger, one (1) 8-output fused access
power controller, one (1) 4-output fused access power controller and one (1) 8-output
fused power distribution module.
This kit also accommodate various combinations of CDVI Atrium A22K/A22NB/ADH10
boards for up to ten (10) doors in a single enclosure. Trove simplifies board layout and
wire management, reduces installation time and labor costs.
T2CVK7F10
Access & Power Integration Solution
Rev. T2CVK7F10 - 03182020
- 24VDC power supply/charger.
- Accommodates up to five (5) CDVI Atrium
A22K/A22NB/ADH10 boards..
- Convenient knockout configuration:
- Single 2” diameter knockout located top center of enclosure
- Sixteen (16) double knockouts (1” and 0.75”).
- 16 AWG galvanized steel backplane simplifies board layout
and wire management.
- Supervision
- AC Fail
- Low Battery and Battery Presence
- Low power shutdown.
- CE European Conformity.
- Enclosure accommodates up to four (4) 12VDC/12AH batteries.
- Lifetime Warranty*/Made in the U.S.A.
Key Features
*Altronix Power Supply/Chargers and Sub-Assemblies only
T2CVK7F10
Accessories (order separately)
LINQ2 - Network Supervision
Altronix LINQ2 Network Communication Module provides remote supervision, control and monitoring over LAN/WAN
- Remotely reports accurate power diagnostics
- Controls power and resets devices
- Reports system diagnostics via Email
WM5, WM25, WM100 - Magnetic Cable Tie Mounts
Altronix WM5, WM25, and WM100 are packs of 5, 25 or 100 magnetic cable tie mounts respectively.
They accommodate standard zip ties or velcro straps. These are ideal for wire management in our Trove series.
MM4, MM8, MM12, MM24 - Magnetic Mounting Solution
Altronix mounting magnets accommodate screws and nylon standoffs to allow for mounting various boards/
accessories in any metal enclosure or backplane.
WM5
LINQ2
Mounting Magnet