Spec Sheet

Description
Altronix T1PDK7F24 kit consists of Trove1 enclosure, TPD1 PDK/Altronix backplane
with one (1) 24VDC @ 10A power supply/charger. This kit also accommodates up
to three (3) PDK PM-07-EIOE-E modules for up to twenty-four (24) doors in a single
enclosure. Trove simplifies board layout and wire management, reduces installation
time and labor costs.
T1PDK7F24
Access & Power Integration Solution
Rev. T1PDK7F24 - 06262020
- 24VDC power supply/charger.
- Accommodates up to three (3) PDK PM-07-EIOE-E modules.
- Convenient knockout configuration:
- Single 1.5” diameter knockout located top center of enclosure
- Nine (9) double knockouts (1” and 0.75”).
- 16 AWG galvanized steel backplane simplifies board layout
and wire management.
- Supervision
- AC Fail
- Low Battery and Battery Presence
- Low power shutdown.
- CE European Conformity.
- Enclosure accommodates up to two (2) 12VDC/7AH batteries.
- Lifetime Warranty* / Made in the U.S.A.
Key Features
T1PDK7F24
*Altronix Power Supply/Chargers and Sub-Assemblies only
Accessories (order separately)
LINQ2 - Network Supervision
Altronix LINQ2 Network Communication Module provides remote supervision, control and monitoring over LAN/WAN
- Remotely reports accurate power diagnostics
- Controls power and resets devices
- Reports system diagnostics via Email
WM5, WM25, WM100 - Magnetic Cable Tie Mounts
Altronix WM5, WM25, and WM100 are packs of 5, 25 or 100 magnetic cable tie mounts respectively.
They accommodate standard zip ties or velcro straps. These are ideal for wire management in our Trove series.
MM4, MM8, MM12, MM24 - Magnetic Mounting Solution
Altronix mounting magnets accommodate screws and nylon standoffs to allow for mounting various boards/
accessories in any metal enclosure or backplane.
WM5
LINQ2
Mounting Magnet