Installation Instructions

Trove1 Mercury ULXB Kits Installation Guide - 3 -
A
B
C
D D
C
B
A
Altronix
AL400ULXB2
Flying
Leads
+ IN - +OUT-
ON-5V
OFF-12V
Altronix - VR6
TRG
TRIGGER
INPUT
ACM4
ACCESS POWER
CONTROLLER
LED1 LED2 LED3 LED4
MAIN
OUTPUT 1
NC C NO COM NC C NO COM NC C NO COM NC C NO COM
OUTPUT 2 OUTPUT 3
IN GND
1
IN GND
2
IN GND
3
IN GND
4
OUTPUT 4
-- +
CONTROL
-- +
POWER
+INP- T +RET-
INTERFACE
NO C NC
FACP
Altronix - ACM4(CB)
L G N
BAT FAIL NC C NO NC C NO
AC FAIL
AC
+ BAT -
+ DC -
DC BAT
F1
Off - 24V On - 12V
SW1
ON
T1MK14 and T1MK14D: Configuration of Mercury Boards:
1. Fasten snap on spacers onto metal pems configuration (A), (B), (C) or (D) of backplane depending on the access controller (Fig. 2, pg. 3).
2. Position access controller module over corresponding spacers and depress onto snap on spacers (Fig. 2a, pg. 3).
3. Mount backplane to enclosure with hardware.
Access Controller Position Chart for the Following Models:
Mercury Access Controller Pem Mounting
EP1502, LP1502, MR52, MR16IN, MR16OUT
A
EP1501, LP1501, MR51e, MR62e
B
MR50
C
EP2500, LP2500, MUX8
D
Fig. 2
Snap On
Spacer
Mercury Board
Backplane
Pem
Fig. 2a