Panic Device Power Controller Installation Guide Altronix Corp. 140 58th St. Brooklyn, NY Rev.
Overview: StrikeIt1 will operate up to two (2) 24VDC panic hardware devices simultaneously. It is designed to handle the high current surge panic hardware locking devices demand. Each lock output has an adjustable relock delay timer. It will control a pair of doors simultaneously or independently control two individual doors. It has a follower relay for each output to trigger external relays, ADA push plate switches, etc.
Connect earth ground to a ground lug or ground lead. Do not connect to a receptacle controlled by a switch. Unit is intended for permanent connection using metal enclosed system. A fixed product shall be connected with one of the applicable wiring systems in accordance with CSA C22.1, Canadian Electrical Code, Part I, Safety Standard for Electrical Installations. Note: StrikeIt1 is intended to be permanently connected. 3. Measure aux. output voltage before connecting devices.
StrikeIt1 LED Diagnostics (cont’d): INP2 - Red Trigger Input 2 FAI - Green BAT Trouble Red AC Trouble Green On Slow Blink Rapid Blink Off On Off Off On Slow Blink Off Slow blink Output 2 - Energized. Output 2 - Open Circuit. Output 2 - Short Circuit. Output 2 - De-energized. FACP Input triggered (alarm condition). FACP normal (non-alarm condition). Normal condition. Manual test initiated. Battery low or missing, active during manual test or AC failure. AC normal. AC low or missing.
--- --- + 12VDC IN2 NC +12VDC– +24VDC– C NO C NO C NO C NO C NO C NO C NO C Auxiliary 24VDC Device Request to Exit PIR AC Supervision Auxiliary Device Automatic Door Operator Auxiliary Device Automatic Door Operator GND – OUT2 + IN1 – OUT1 + GND + BAT – N GND G FACP 25A 32V L NC FAULT 1 2 3 4 25A NO ON 6.3A C OUT1 OUT2 TIMER TIMER 6.3A 250V Delayed 1 Follower 1 MIN Option 1-Option 2 24-5V Hold Voltage Follow-up Delay 0.5-1 sec.
.3A Fig. 2 AC Power LED L AC 6.3A 250V G N 25A + BAT – Battery + 24VDC -- OUT1 and OUT2 25A 32V Relock delay adjustment. Used to hold OUT1 or OUT2 energized after a momentary closure across IN1 or IN2. Set for 0 seconds for output to follow input. Turn clockwise to increase time. Output 1 – OUT1 + Output 2 Fire Alarm Interface Input #1 Input #2 IN1 Connect normally open dry contacts from key switch, timer, remote release or any maintained/momentary switch.
NO +12VDC– +24VDC– Tamper Switch IN2 115VAC Input 60Hz, 5 amp (non powerlimited) Power-Limited Outputs Class 2 Dry C NC +12VDC– +24VDC– C NO C NO C NO C NO C NC C NO C NO FAULT IN2 Power-Limited Aux. Outputs Class 2 Dry Power-Limited Outputs Class 2 Dry GND GND IN1 – OUT2 + Delayed 2 Follower 2 1 2 3 4 Battery Outputs (non powerlimited) – OUT1 + FACP + BAT – C N 25A 32V NO G GND GND IN1 – OUT2 + GND L Delayed 1 Fig. 3a C NO C NO NC ON 25A GND 6.3A NC NO C 6.
NEC Power-Limited Wiring Requirements for StrikeIt1 Model: Power-limited and non power-limited circuit wiring must remain separated in the cabinet. All power-limited circuit wiring must remain at least 0.25” away from any non power-limited circuit wiring. Furthermore, all power-limited circuit wiring and non power-limited circuit wiring must enter and exit the cabinet through different conduits. One such example of this is shown below.
Enclosure Dimensions (H x W x D approximate): 13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.55mm) 1.40” (36mm) 4.85” (123mm) 4.85” (123mm) 1.40” (36mm) 1.20” (31mm) 3.25” (83mm) 1.20” (31mm) 0.75” (19mm) 12.5” (318mm) 11.0” (279mm) 1.20” (31mm) 0.75” (19mm) 0.9375” (24mm) 1.40” (36mm) 1.40” (36mm) 5.10” (130mm) 5.10” (130mm) 13.0” (330mm) 5.10” (130mm) 6.5625” (167mm) 0.9375” (24mm) 3.25” (83mm) 3.25” (83mm) 3.25” (83mm) 1.0” (25mm) 1.0” (25mm) 1.0” (25mm) StrikeIt1 10.5” (267mm) 1.
Notes: - 10 - StrikeIt1
Notes: StrikeIt1 - 11 -
Notes: Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 website: www.altronix.com, e-mail: info@altronix.com. Lifetime Warranty. Made in U.S.A.
