Installation Instructions

PT2724 Installation Guide - 7 -
Depressing UP push button will now clear all events previously programmed. If you wish to escape from
this selection depress any of the other push buttons: SET, ENTER and DOWN.
H. Tandem Relay Mode:
To operate in the Tandem Relay Mode, turn switch SW2 ON. This mode setting will allow events
programmed for Channel A and Channel B to operate both relays simultaneously (1 DPDT relay output).
This setting doubles the amount of programmable events.
Note: When using the Tandem Relay mode, sequential On/Off or Off/On events must be programmed in
the same channel. (If there is a Channel Program conflict, such as CH A is set to ON and Channel B is set
to OFF. The ON command will override the OFF and both relays will remain ON.
Customer Event Log
Event # Relay # Day/Block Holiday Dates Event Type