Installation Instructions

- 4 - PT2724 Installation Guide
Push Button Layout:
Push Button Description Table:
Push Button Function/Description
SET
Scrolling keys for programming. Escaping out of existing programming.
ENTER
Accepts selections made to programming.
UP
Scrolls through selections.
DOWN
Scrolls through selections.
UP and DOWN keys can be used to select data entries.
After scrolling to the correct entry, depress ENTER to accept.
SW2 DIP Switch Selects tandem or individual relay operation.
SW3 Slide Switch Selects channel to be programmed.
Programming Instructions:
A. Setting Clock/Calendar:
Upon initial power up will appear on display.
Depress SET. will appear on display.
Depress ENTER. will appear on display.
Enter the current date, day of week and time (military) by depressing UP and DWN to make the selection,
then depress ENTER to accept.
Next, select either DS (daylight savings mode) or ST (standard time mode) by depressing SET until
appears on display.
Depress ENTER to scroll until flashing cursor appears under DS (daylight savings mode) in display.
To change mode depress UP or DWN until ST (standard time mode) will appear in display.
Depress ENTER to accept correct selection.
Note: The flashing cursor denotes location of data entry selection to be made. If an entry was made in
error or requires changing, depress SET to backspace, make the correct selection and depress ENTER to
accept data and advance the cursor. To change or program clock/calendar simply repeat the steps above.
B. Setting and Adding Events:
Select channel A or B by moving slide switch SW3 to appropriate position.
Note: Channel cannot be changed in the middle of programming events. To change channels, you must
exit programming then change channel switch position then enter program mode again.
1. Setting Events
Depress SET until appears on display.
Depress ENTER. will appear on display.
Note: A01 indicates Channel A event 01. When cursor appears, you are able to scroll through events.
SET
ENTER
UP
DWN
RLY OFF
SU 01:01
ENTER to
SET TIME
01/01/01
SU/01:01
ENTER to
SET BK
>
A01 OFF
SU 00:00
ENTER to
SET EVENT
>