Power over the Ethernet Installation Guide Models Include: NetWaySP4P - 4-port Fiber Optic Transceiver with Built-in Power Supply for Composite Fiber (Powered) Cable NetWaySP4P2 - 4-port Fiber Optic Transceiver with Power-Limited Outputs for Composite Fiber (Powered) Cable DOC#: NETSP Rev. 020217 More than just power.
Table of Contents: Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . pg. 3 Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview: Altronix NetWaySP4P/NetWaySP4P2 Fiber Optic Transceivers provide four (4) 1Gb SFP ports and four (4) ports for up to 120W per port to be transmitted over composite fiber (powered) cable (fiber + copper combined) to NetWay Spectrum PoE Hardened Switches. NetWaySP4P/NetWaySP4P2 can be used for standard fiber cable applications as well. Features: Agency Listings: • UL/cUL • CE UL 60950-1 (Information Technology Equipment). European Conformity. Input: • 115VAC, 60Hz, 3.
. Connect structured cable from ethernet switch/NVR (network video server) to RJ45 jack marked [Ethernet 1-4] (Fig. 2e, pg. 4). Note: All cabling and wire must be UL Listed and/or Recognized wire suitable for their application. 5. Connect Composite (Powered) Fiber cable: fiber portion to port marked [SFP 1-4], copper portion connects to output marked [OUT 56VDC, 1-4] (Fig. 2b & 2d, pg. 4). 6.
NetWaySP4P / NetWaySP4P2 -5- Rear Panel Front Panel WiFi Access Point PoE+ Camera PoE+ Camera Fig.
Technical Specifications: Parameter Number of Ports Description Four (4) Gigabit SFP Ports. Four (4) ports 10/100/1000Mbps. Power Outputs NetWaySP4P: NetWaySP4P2: Input power requirements 115VAC, 60Hz, 3.25A or 230VAC, 50/60Hz, 2.0A. Four (4) 56VDC non power-limited outputs 120W max. Four (4) 56VDC power-limited outputs @ 60W each.
Notes: NetWaySP4P / NetWaySP4P2 -7-
Rack Mount Installation Mounting Options: 1. Remove and discard factory installed screws from both sides of rack chassis (Fig. 4a). 2. Install mounting brackets (A) on the left and right side of rack chassis using the four (4) flat head screws (B) (included) (Fig. 4b). 3. Place unit into desired EIA 19” rack position and secure with mounting screws (not included) (Fig. 4c). Fig. 4 Fig. 4a Fig. 4b Top Fig. 4c Top Top Front Left Front Left Front Left B Remove A Wall Mount Installation 1.
