Installation Guide

ManualsBrandsAltronix ManualsFiber Optic Transmission802.3bt Media Converter/Injector with Integral Power, Outdoor Enclosure

NetWaySP1BT Series - 5 -

5A 250VA

--- DC +- BAT +

To Stand-by

Batteries

115VAC 230VAC

Ground

LG N

NetWaySP1BT

802.3bt Converter/Injector

Input: 48–56VDC

Output: IEEE 802.3bt (90W)

48-56VDC

-- Input +

802.3bt

Output

Data

Port

Fiber

Signal

PoE

Signal SFP

Input Voltage

Selection Switch

Input/Data Connections:

1. Connect structured cable from port marked [Data Port] on NetWaySP1BT to a PoE midspan/endspan

(Fig. 4, pg. 5).

2. Connect fiber optic cable to a fiber SFP module. Connect the module to the port marked [SFP] on the

NetWaySP1BT. Connect the other end of fiber cable to an SFP module of a remote device.

SFP LED will illuminate indicating data connection (Fig. 4, pg. 5).

3. Using 4-pair CAT5e or higher cable connect PoE load device to be powered to the port marked

[802.3bt Output] on NetWaySP1BT. After authentication and classification have been established,

[PoE Signal] LED will illuminate indicating PoE presence.

Ethernet Data Port

Yellow LED

10/100 Mbps

Green LED 1000 Mbps

IEEE 802.3af, 802.3at and 802.3bt

compliant port rated up to 90W max

48VDC to 56VDC

Input

-- +

SFP LED Indicates

data connection

PoE LED indicates PoE present

One (1) Gb SFP port

for Fiber

48-56VDC

– Input +

802.3bt

Output

Data

Port

Fiber

Signal

PoE

Signal

SFP

Fig. 3

Fig. 4

Fig. 3a