Installation Guide

- 6 - NetWayG
NetWayG Typical Applications:
NetWay8G is shown (similar to NetWay8GP).
NetWay16G is similar with twice as many ports
Fig. 4
NetWay8G - Front Panel
Ethernet Switch
Programming
and Status
NVR/Network Server
PoE
Camera
PoE
Camera
NetWayXT/NetWayXTX
Extends Ethernet
100m
Pace
Long Range Ethernet Adapters
Extends Ethernet approx. 500m
Receiver
Transceiver
NetwayXT
Repeater
IN
OUT
Power
I.T.E. 43KC
www.altronix.com
Made in U.S.A.
Card
Reader
HID Solo
Strike
Typical UL294
Application:
PoE/PoE+/Hi-PoE
Camera
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user
to the presence of an insulated DANGEROUS VOLTAGE within the product’s enclosure that may be
of sufficient magnitude to constitute an electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying
the appliance.
CAUTION: To reduce the risk of electric shock do not open
enclosure. There are no user serviceable parts inside.
Refer servicing to qualified service personnel.
Configuring NetWayG for Network Connection
Please be sure to visit altronix.com for latest firmware and installation instructions
Factory Default Settings
• IP Address: 192.168.168.168
• User Name: admin
• Password: admin
1. Set the static IP address for the laptop to be used for programming to the same network IP address as the
NetWayG. The default address of the NetWayG is 192.168.168.168, E.I. 192.168.168.200.
2. Connect one end of the network cable to the network jack on the NetWayG and the other to the network
connection of the laptop.
3. Open a browser on the computer and enter “192.168.168.168” into the address bar. A dialog box
Authentication Required will appear requesting both user name and password.
Enter the default values here. Click on the button labeled Log In.
4. The status page of the NetWayG will appear. Click on the tab labeled Network Settings. This will open
the Network Setting screen. In this screen the MAC Address of the NetWayG module will be found along
with the Network Settings and Email Settings.